Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > AUTO LSD Indicator Light does not Come ON

for Preparation Click here


DESCRIPTION

Refer to the description of "AUTO LSD Indicator Light Remains ON" .

WIRING DIAGRAM

Refer to the AUTO LSD indicator light circuit .

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

Result:
Result
Proceed to
DTC is not output.
A
DTC is output.
B



B
REPAIR CAN COMMUNICATION SYSTEM (Click here)
A


2.READ VALUE USING INTELLIGENT TESTER (AUTO LSD SWITCH)
  1. Check the Data List for proper functioning of the AUTO LSD switch (Click here).

    ABS/VSC/TRC: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Auto LSD Switch
    Traction control switch (VSC OFF switch) / ON or OFF
    ON: VSC OFF switch is on
    OFF: VSC OFF switch is off
    -

    OK:
    ON (VSC OFF switch is on) appears on the screen.



NG
Go to step 5
OK


3.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (AUTO LSD INDICATOR LIGHT)
  1. Connect the intelligent tester to the DLC3.

  1. Start the engine.

  1. Select the Active Test mode on the intelligent tester (Click here).

    ABS/VSC/TRC: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Auto LSD Indicator Light
    AUTO LSD indicator light
    Indicator light ON / OFF
    Observe the combination meter.

    OK:
    The AUTO LSD indicator light turns ON and OFF.



NG
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
OK


4.INSPECT COMBINATION METER ASSEMBLY
  1. Inspect the combination meter (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)  

5.INSPECT TRACTION CONTROL SWITCH (VSC OFF SWITCH)


    C194196E02
  1. Remove the VSC OFF switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 (E) - 9 (+)
    Not pushed
    10 kΩ or higher
    Pushed
    Below 1Ω



NG
REPLACE TRACTION CONTROL SWITCH (VSC OFF SWITCH)
OK


6.CHECK HARNESS AND CONNECTOR (VSC OFF SWITCH - SKID CONTROL ECU/BODY GROUND)
C194149E02
  1. Disconnect the skid control ECU connector.

  1. Disconnect the VSC OFF switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A67-30 (CSW) - E96-9 (+)
    Always
    Below 1 Ω
    A67-30 (CSW) - Body ground
    Always
    10 kΩ or higher
    E96-6 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)