Home › SUSPENSION & AXLE › AXLE › REAR AXLE HUB BOLT

REAR AXLE HUB BOLT > REPLACEMENT

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are the LH side.



1. REMOVE REAR WHEEL


2. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH
  1. Remove the rear disc brake cylinder assembly (Click here).



3. REMOVE REAR DISC


    C129072E01
  1. Put matchmarks on the disc and axle hub.

  1. Release the parking brake.



    C127304
  1. Turn the shoe adjuster until the disc turns freely, and then remove the disc.

  1. Install the shoe adjusting hole plug to the rear disc.



4. REMOVE REAR AXLE HUB BOLT


    C130576E01
  1. Using SST and a brass bar or equivalent to hold the axle shaft, remove the hub bolt that needs to be replaced.

    SST
    09650-17011  



5. INSTALL REAR AXLE HUB BOLT


    C159693E03
  1. Insert a new hub bolt into the bolt hole. Set a plate washer and nut on the hub bolt end.

  1. Using a brass bar or equivalent to hold the rear axle, install the hub bolt by tightening the nut. Then remove the nut and plate washer.



6. INSTALL REAR DISC


    C127291E01
  1. Align the matchmarks and install the disc.

    HINT:
    When replacing the disc with a new one, select the installation position where the disc has the smallest runout.



7. INSTALL REAR DISC BRAKE CYLINDER ASSEMBLY LH
  1. Install the rear disc brake cylinder assembly (Click here).



8. INSTALL REAR WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }