Home › HEATER & AIR CONDITIONING SYSTEM › HEATER › COMBUSTION TYPE POWER HEATER SYSTEM

DTC    010    Over Voltage Shutoff

DTC    011    Under Voltage Shutoff

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
010
Battery voltage is 14 V or higher for 20 seconds or more.
  1. Harness or connector
  2. Heater assembly
011
Battery voltage is 11 V or less for 20 seconds or more.

WIRING DIAGRAM


E176183E10


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
Before performing the following procedures, check the battery and generator assembly and confirm that they are operating normally.

1.CHECK HARNESS AND CONNECTOR (HEATER ASSEMBLY - BATTERY AND BODY GROUND)


    E176184E13
  1. Disconnect the A31 heater connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A31-5 (B) - Body ground
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A31-1 (E) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*1
Front view of wire harness connector
(to Heater Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE HEATER ASSEMBLY (Click here)