Home › HEATER & AIR CONDITIONING SYSTEM › HEATER › COMBUSTION TYPE POWER HEATER SYSTEM

DTC    047    Short in Heater Fuel Pump Circuit

DTC    048    Heater Fuel Pump Malfunction

DTC    049    Heater Fuel Pump Output Error

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
047
A short is detected in the heater pump assembly circuit.
  1. Harness or connector
  2. Heater pump assembly
  3. Heater assembly
048
Operation stop of the heater pump assembly is detected (open in the circuit).
  1. Harness or connector
  2. Heater pump assembly
  3. Heater assembly
049
An error is detected in the output to the heater pump assembly.
  1. Harness or connector
  2. Heater pump assembly
  3. Heater assembly (ECU)

WIRING DIAGRAM


E181362E04


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (HEATER ASSEMBLY - HEATER PUMP ASSEMBLY)


    E176772E06
  1. Disconnect the A31 heater connector.

  1. Disconnect the A28 pump connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A31-2 (L) - A28-1
    Always
    Below 1 Ω
    A31-2 (L) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Heater Assembly)
    *2
    Front view of wire harness connector
    (to Heater Pump Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (HEATER PUMP ASSEMBLY - BODY GROUND)


    E176913E06
  1. Disconnect the A28 pump connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A28-2 - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Heater Pump Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT HEATER PUMP ASSEMBLY


    E176914
  1. Remove the heater pump assembly with the fuel hose still connected (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Always
    9 to 12 Ω

  1. Apply battery voltage to the heater pump assembly and check the pressure of the hose by hand.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 2
    Pressure is applied to the hose

    NOTICE:
    1. This inspection must be done quickly (within 10 seconds) to prevent damage to the heater pump assembly.
    2. Always switch the voltage on and off on the battery side, not the heater pump assembly side.
    3. Keep the heater pump assembly as far away from the battery as possible.



NG
REPLACE HEATER PUMP ASSEMBLY (Click here)
OK

REPLACE HEATER ASSEMBLY (Click here)