Home › HEATER & AIR CONDITIONING SYSTEM › HEATER › COMBUSTION TYPE POWER HEATER SYSTEM

DTC    051    Cold Blow Time Exceeded

for Preparation Click here


DESCRIPTION


DTC Code
DTC Detection Condition
Trouble Area
051
After the heater assembly is turned on, the temperature of the flame sensor is 90°C (194°F) or higher for 600 seconds or more before heater ignition begins.
  1. No. 1 exhaust pipe sub-assembly
  2. No. 2 exhaust pipe sub-assembly
  3. Heater assembly

INSPECTION PROCEDURE

HINT:
Before performing the following inspection, attempt to restart the heater assembly. If the heater assembly is successfully started, confirm that DTC 051 is not output. If DTC 051 is not output, stop troubleshooting because it can be concluded that the system has returned to normal.

1.INSPECT EXHAUST PIPE SUB-ASSEMBLY
  1. Check that hot exhaust gas is coming out of the exhaust pipes.

    CAUTION:
    1. The exhaust pipes and muffler are extremely hot. Wear protective gloves and do not touch these parts with bare hands.
    2. When performing the inspection, wear a face mask to prevent direct inhalation of exhaust gas.

    Result 
    Result
    Proceed to
    There is no problem with the exhaust pipes.
    A
    There is a problem with the exhaust pipe (No. 1 exhaust pipe sub-assembly).
    B
    There is a problem with the exhaust pipe (No. 2 exhaust pipe sub-assembly).
    C



B
CLEAN OR REPLACE NO. 1 EXHAUST PIPE SUB-ASSEMBLY (Click here)

C
CLEAN OR REPLACE NO. 2 EXHAUST PIPE SUB-ASSEMBLY (Click here)
A

REPLACE HEATER ASSEMBLY (Click here)