Home › BODY › SLIDING ROOF › SLIDING ROOF SYSTEM

DTC    B2343    Position Initialization Incomplete

for Preparation Click here


DESCRIPTION

This DTC is output when the sliding roof drive gear (sliding roof ECU) has not been initialized.

DTC Code
DTC Detection Condition
Trouble Area
B2343
Sliding roof drive gear (sliding roof ECU) has not been initialized
  1. Sliding roof drive gear sub-assembly (sliding roof ECU)
  2. Map light assembly (sliding roof control switch)
  3. Wire harness

WIRING DIAGRAM

Refer to DTC B2341 .

INSPECTION PROCEDURE

1.INITIALIZE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)
  1. Check that the sliding roof drive gear can be initialized (Click here).

    OK:
    Sliding roof drive gear can be initialized.



NG
Go to step 3
OK


2.CHECK SLIDING ROOF FUNCTION
  1. Check the auto operation with the SLIDE OPEN and TILT UP switch (Click here).

    OK:
    Auto operation operates normally with SLIDE OPEN and TILT UP switch.



NG
REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)
OK

END 

3.CHECK WIRE HARNESS (SLIDING ROOF DRIVE GEAR - MAP LIGHT ASSEMBLY)


    B130118E22
  1. Disconnect the R9 gear connector.

  1. Disconnect the R8 map light connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    R9-7 (DWN) - R8-9 (DOWN)
    Below 1 Ω
    R9-9 (UP) - R8-8 (UP)
    Below 1 Ω
    R8-7 (GND) - Body ground
    Below 1 Ω
    R8-9 (DOWN) - Body ground
    10 kΩ or higher
    R8-8 (UP) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.INSPECT MAP LIGHT ASSEMBLY (SLIDING ROOF CONTROL SWITCH)


    E164298E04
  1. Remove the map light assembly.

  1. Measure the resistance of the switch.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    8 (UP) - 7 (GND)
    TILT UP switch pushed
    Below 1 Ω
    8 (UP) - 7 (GND)
    TILT UP switch not pushed
    10 kΩ or higher
    9 (DOWN) - 7 (GND)
    SLIDE OPEN switch pushed
    Below 1 Ω
    9 (DOWN) - 7 (GND)
    SLIDE OPEN switch not pushed
    10 kΩ or higher



NG
REPLACE MAP LIGHT ASSEMBLY (SLIDING ROOF CONTROL SWITCH)
OK

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (SLIDING ROOF ECU)