Home › TRANSMISSION ยท U660F AUTOMATIC TRANSAXLE › DIFFERENTIAL OIL SEAL (for RH Side)

DIFFERENTIAL OIL SEAL (for RH Side) > REPLACEMENT

for Preparation Click here



1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY
  1. Remove the automatic transaxle (Click here).



2. REMOVE TRANSFER ASSEMBLY


C126622
  1. Remove the 6 nuts, 2 bolts and transfer from the transaxle.



3. REMOVE TRANSAXLE CASE OIL SEAL RH


    C139836E02
  1. for Outside:

    1. Using a screwdriver with its tip wrapped with vinyl tape, pry out the transaxle case oil seal.
      Text in Illustration 
      *1
      Vinyl Tape

      NOTICE:
      Be careful not to damage the housing.



    C139837E02
  1. for Inside:

    1. Using SST, tap out the transaxle case oil seal.

      SST
      09308-00010  

      NOTICE:
      Be careful not to damage the housing.



4. INSTALL TRANSAXLE CASE OIL SEAL RH


    C188860E01
  1. for Inside:

    1. Coat the lip of a new transaxle case oil seal with MP grease.

    2. Using SST and a hammer, tap in the transaxle case oil seal.

      SST
      09950-60010   (09951-00410)
      09950-70010   (09951-07200)

      Standard depth:
      21.5 to 22.5 mm (0.846 to 0.886 in.)



    C188861E01
  1. for Outside:

    1. Coat the lip of a new transaxle case oil seal with MP grease.

    2. Using SST and a hammer, tap in the transaxle case oil seal.

      SST
      09649-17010  
      09950-70010   (09951-07200)

      Standard depth:
      5.5 to 6.5 mm (0.217 to 0.256 in.)

      NOTICE:
      Make sure that the oil seal is installed in the correct direction.



5. INSTALL TRANSFER ASSEMBLY


C126622
  1. Install the transfer to the transaxle with the 6 nuts and 2 bolts.

    Torque:
    69 N*m{ 700 kgf*cm , 51 ft.*lbf }



6. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY
  1. Install the automatic transaxle (Click here).