DTC C1436 Yaw Rate Sensor Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1436 | Either of the following is detected:
| Yaw rate and deceleration sensor |
| 1.READ VALUE USING INTELLIGENT TESTER (YAW RATE SENSOR) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Select the Data List mode on the intelligent tester (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Yaw Rate Sensor | Yaw rate sensor 1 reading / min.: -128 deg/s, max.: 127 deg/s | Vehicle stationary: 0 deg/s Right turn: -128 to 0 deg/s Left turn: 0 to 127 deg/s | - |
Check that the yaw rate and deceleration sensor output value displayed on the intelligent tester.
| Result | Proceed to | |
| NG | The yaw rate and deceleration sensor output value is 0 deg/s when the vehicle is stationary, but the value fluctuates when turning. | A |
| The yaw rate and deceleration sensor output value is not 0 deg/s when the vehicle is stationary. | B | |
| OK | C | |
|
| ||||
|
| ||||
| A | |
| 2.CHECK YAW RATE AND DECELERATION SENSOR INSTALLATION |
Turn the ignition switch off.
Check that the yaw rate and deceleration sensor has been installed properly .
|
| ||||
| OK | ||
| ||