Home › ENGINE ยท 2AD-FHV › ENGINE MECHANICAL › CYLINDER HEAD GASKET

CYLINDER HEAD GASKET > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
w/ Navigation System (for HDD):
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE EXHAUST MANIFOLD WITH TURBOCHARGER
  1. Remove the exhaust manifold with turbocharger (Click here).



3. REMOVE CAMSHAFT
  1. Remove the camshafts (Click here).



4. REMOVE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY


    A201783E01
  1. Remove the bolt, washer, nozzle holder clamp, exhaust fuel addition injector and gasket.
    Text in Illustration 
    *1
    Washer
    *2
    Nozzle Holder Clamp



5. REMOVE FUEL INJECTOR SEAL


    A206481
  1. Remove the fuel injector seal from the exhaust fuel addition injector.



6. REMOVE GLOW PLUG ASSEMBLY


    A203778
  1. Remove the 4 grommets.

  1. Remove the 4 nuts and No. 1 glow plug connector.

  1. Using a 10 mm deep socket wrench, remove the 4 glow plugs.



7. REMOVE CYLINDER HEAD SUB-ASSEMBLY


    A202398E01
  1. Uniformly loosen the 10 bolts in several steps, in the sequence shown in the illustration. Remove the 10 cylinder head bolts and plate washers.

    NOTICE:
    1. Do not drop the washers into the cylinder head.
    2. Head warpage or cracking could result from removing bolts in the incorrect order.



8. REMOVE CYLINDER HEAD GASKET


    A202400
  1. Remove the cylinder head gasket.