Home › ENGINE ยท 2AD-FTV › EMISSION CONTROL › EXHAUST MANIFOLD CONVERTER (for CCo)

EXHAUST MANIFOLD CONVERTER (for CCo) > INSTALLATION

for Preparation Click here



1. INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY


  1. Install a new gasket to the turbocharger.

    HINT:
    A206476E01
    Make sure that the part labeled A is facing downwards as shown in the illustration.



    A197484
  1. Temporarily install the exhaust manifold converter with the 3 nuts.



    A197503
  1. Temporarily install the No. 2 exhaust manifold stay with the 2 bolts and nut.



    A197502
  1. Temporarily install the No. 2 manifold stay with the 3 bolts.



    A197504
  1. Temporarily install the manifold stay with the bolt and nut.



    A201857E01
  1. Tighten the 2 bolts of the No. 2 exhaust manifold stay in the order shown in the illustration.

    Torque:
    56 N*m{ 571 kgf*cm , 41 ft.*lbf }



    A197484
  1. Tighten the 3 nuts of the exhaust manifold converter.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    NOTICE:
    Tighten the nuts while pressing the exhaust manifold converter against the engine.



    A201858
  1. Tighten the nut of the No. 2 exhaust manifold stay.

    Torque:
    56 N*m{ 571 kgf*cm , 41 ft.*lbf }



    A201859
  1. Tighten the bolt of the No. 2 manifold stay shown in the illustration.

    Torque:
    56 N*m{ 571 kgf*cm , 41 ft.*lbf }

    NOTICE:
    Tighten the bolt while pressing the No. 2 manifold stay against the exhaust manifold converter and cylinder block.



    A201860
  1. Tighten the 2 bolts of the No. 2 manifold stay shown in the illustration.

    Torque:
    56 N*m{ 571 kgf*cm , 41 ft.*lbf }



    A201861
  1. Tighten the bolt of the manifold stay.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    NOTICE:
    Tighten the bolt while pressing the manifold stay against the exhaust manifold converter and cylinder block.



    A201862
  1. Tighten the nut of the manifold stay.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }



2. INSTALL NO. 1 MANIFOLD CONVERTER INSULATOR


    A197501
  1. Install the insulator with the 4 bolts.

    Torque:
    29 N*m{ 291 kgf*cm , 21 ft.*lbf }



3. INSTALL ENGINE ASSEMBLY
  1. Install the engine assembly (Click here).