Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (w/o Navigation System)

REAR VIEW MONITOR SYSTEM (w/o Navigation System) > Display Signal Circuit between Inner Rear View Mirror Assembly and Television Camera Assembly

for Preparation Click here


DESCRIPTION

This is the display signal circuit of the television camera.

WIRING DIAGRAM


E182129E09


INSPECTION PROCEDURE

1.CHECK INNER REAR VIEW MIRROR ASSEMBLY
E173535E02
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    R11-14 (CB+) - R11-13 (CGND)
    Ignition switch ON, shift lever in R
    5.5 to 7.05 V



NG
REPLACE INNER REAR VIEW MIRROR ASSEMBLY (Click here)
OK


2.CHECK TELEVISION CAMERA ASSEMBLY

E173337E02

  1. Using an oscilloscope, check the waveform.
    Measurement Condition 
    Item
    Content
    Tester Connection
    R11-7 (CV+) - R11-6 (CV-)
    Tool Setting
    0.2 V/DIV., 50 μs/DIV.
    Condition
    1. Ignition switch ON, shift lever in R*1
    2. Ignition switch ON, shift lever in R, screen is blacked out by covering camera lens*2

    OK:
    Waveform is as shown in illustration.



NG
Go to step 3
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

3.CHECK HARNESS AND CONNECTOR (INNER REAR VIEW MIRROR ASSEMBLY - TELEVISION CAMERA ASSEMBLY)
E173385E02
  1. Disconnect the R11 inner rear view mirror assembly connector.

  1. Disconnect the S7 television camera assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R11-14 (CB+) - S7-4 (CB+)
    Always
    Below 1 Ω
    R11-13 (CGND) - S7-3 (CGND)
    Always
    Below 1 Ω
    R11-7 (CV+) - S7-2 (CV+)
    Always
    Below 1 Ω
    R11-6 (CV-) - S7-1 (CV-)
    Always
    Below 1 Ω
    R11-14 (CB+) - Body ground
    Always
    10 kΩ or higher
    R11-13 (CGND) - Body ground
    Always
    10 kΩ or higher
    R11-7 (CV+) - Body ground
    Always
    10 kΩ or higher
    R11-6 (CV-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TELEVISION CAMERA ASSEMBLY (Click here)