SPEED SENSOR > INSTALLATION |
| 1. INSTALL SPEED SENSOR |
![]() |
Coat the 2 bolts with ATF.
Install the speed sensor to the valve body with the 2 bolts.
Connect the connector.
| 2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY |
Coat the O-ring of the transmission wire connector with ATF.
Align the groove of the manual valve with the manual valve lever.
![]() |
Install the valve body to the transaxle case with the 11 bolts.
| 3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY |
![]() |
Coat a new O-ring with ATF and install it to the oil strainer.
![]() |
Install the oil strainer to the valve body with the 2 bolts.
| 4. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY |
![]() |
Install the 2 magnets to the oil pan.
| *1 | Magnet |
Install a new gasket to the oil pan.
![]() |
Apply seal packing to the bolt labeled A in the illustration.
Install the oil pan to the automatic transaxle with the 18 bolts.
| 5. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT LH |
![]() |
Install the front suspension member reinforcement with the 4 bolts.
| 6. ADD AUTOMATIC TRANSAXLE FLUID |
Add automatic transaxle fluid (Click here).
| 7. INSTALL REAR ENGINE UNDER COVER LH |
Install the under cover with the 2 clips.
| 8. INSTALL NO. 1 ENGINE UNDER COVER |
Install the engine under cover with the 6 bolts and 10 clips.