Home › TRANSMISSION ยท U660F AUTOMATIC TRANSAXLE › ATF TEMPERATURE SENSOR

ATF TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL ATF TEMPERATURE SENSOR ASSEMBLY


C138520E03
  1. Coat a new O-ring with ATF and install it to the ATF temperature sensor.
    Text in Illustration 
    *1
    New O-Ring

  1. Coat the 4 bolts with ATF.



    C139240E08
  1. Install the ATF temperature sensor and clamp to the valve body with the 4 bolts.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }

    Text in Illustration 
    *1
    Clamp

    HINT:
    Each bolt length is indicated below.
    Bolt A: 25 mm (0.984 in.)
    Bolt B: 85 mm (3.35 in.)

  1. Connect the connector.



2. INSTALL VALVE BODY OIL STRAINER ASSEMBLY


C136688
  1. Coat a new O-ring with ATF and install it to the oil strainer.

    NOTICE:
    Ensure that the O-ring is not twisted or pinched.



    C136687
  1. Install the oil strainer to the valve body with the 2 bolts.

    Torque:
    11 N*m{ 110 kgf*cm , 8 ft.*lbf }



3. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY


C134963E05
  1. Install the 2 magnets to the oil pan.
    Text in Illustration 
    *1
    Magnet

  1. Install a new gasket to the oil pan.



    C134962E01
  1. Apply seal packing to the bolt labeled A in the illustration.

    Seal packing:
    Toyota Genuine Seal Packing 1281,
    Three Bond 1281 or equivalent

  1. Install the oil pan to the automatic transaxle with the 18 bolts.

    Torque:
    for bolt labeled A:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }
    for other bolts:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    NOTICE:
    1. In order to ensure proper sealing of the transmission oil pan bolt, apply seal packing to the bolt and install it within 10 minutes of seal packing application.
    2. Completely remove any oil or grease from the contact surfaces of the transaxle case, oil pan sub-assembly and gasket before installation.



4. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT LH


C207602
  1. Install the front suspension member reinforcement with the 4 bolts.

    Torque:
    96 N*m{ 979 kgf*cm , 71 ft.*lbf }



5. ADD AUTOMATIC TRANSAXLE FLUID
  1. Add automatic transaxle fluid (Click here).



6. INSTALL REAR ENGINE UNDER COVER LH
  1. Install the under cover with the 2 clips.



7. INSTALL NO. 1 ENGINE UNDER COVER
  1. Install the engine under cover with the 6 bolts and 10 clips.