TRANSMISSION WIRE > INSTALLATION |
| 1. INSTALL TRANSMISSION WIRE |
![]() |
Coat the O-ring of the transmission wire connector with ATF.
Coat the bolt with ATF.
Install the transmission wire to the valve body with the lock plate and bolt.
Attach the transmission wire to the wire harness clamp and connect the 9 connectors.
| 2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY |
Coat the O-ring of the transmission wire connector with ATF.
Align the groove of the manual valve with the manual valve lever.
![]() |
Install the valve body to the transaxle case with the 11 bolts.
| 3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY |
![]() |
Coat a new O-ring with ATF and install it to the oil strainer.
![]() |
Install the oil strainer to the valve body with the 2 bolts.
| 4. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY |
![]() |
Install the 2 magnets to the oil pan.
| *1 | Magnet |
Install a new gasket to the oil pan.
![]() |
Apply seal packing to the bolt labeled A in the illustration.
Install the oil pan to the automatic transaxle with the 18 bolts.
| 5. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT LH |
![]() |
Install the front suspension member reinforcement with the 4 bolts.
| 6. ADD AUTOMATIC TRANSAXLE FLUID |
Add automatic transaxle fluid (Click here).
| 7. INSTALL REAR ENGINE UNDER COVER LH |
Install the under cover with the 2 clips.
| 8. INSTALL NO. 1 ENGINE UNDER COVER |
Install the engine under cover with the 6 bolts and 10 clips.