ANTI-LOCK BRAKE SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC (When Using Intelligent Tester) |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Read the DTCs by following the prompts on the tester screen.
| CLEAR DTC (When Using Intelligent Tester) |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Operate the intelligent tester to clear the codes.
| CHECK DTC (When not Using Intelligent Tester) |
![]() |
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
Turn the ignition switch to ON.
w/o Multi-information display: Read DTCs from the ABS warning light on the combination meter.
w/ Multi-information display: Read DTCs from the ABS warning light and the multi-information display on the combination meter.
| Section Title | See Page |
| ABS Warning Light does not Come ON |
Click here
|
| TC and CG Terminal Circuit |
Click here
|

After completing the check, disconnect SST from terminals 13 (TC) and 4 (CG) of the DLC3, and turn the ignition switch off.
| CLEAR DTC (When not Using Intelligent Tester) |
![]() |
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
Turn the ignition switch to ON.
![]() |
Clear the DTCs stored in the skid control ECU by depressing the brake pedal 8 times or more within 5 seconds.
Check that the warning light blinks in the normal system code pattern.
Remove SST from the terminals of the DLC3.
Turn the ignition switch off.
| END OF DTC CHECK/CLEAR |
Turn the ignition switch to ON.
Check that the ABS warning light goes off within approximately 3 seconds.
Turn the ignition switch off.