Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

ANTI-LOCK BRAKE SYSTEM > ABS Warning Light Remains ON

for Preparation Click here


DESCRIPTION

If any of the following conditions are detected, the ABS warning light remains on:
  1. The ECU connectors are disconnected from the skid control ECU.
  2. There is a malfunction in the skid control ECU internal circuit.
  3. There is an open or short in the wire harness between the combination meter and the skid control ECU.

HINT:
The intelligent tester may not be used when there is a malfunction in the skid control ECU.


WIRING DIAGRAM


C203549E01


INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.INSPECT SKID CONTROL ECU CONNECTOR
  1. Check if the skid control ECU connector is properly installed.

    OK:
    The skid control ECU connector is properly installed.



NG
CONNECT CONNECTOR TO ECU SECURELY
OK


3.CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY AND BODY GROUND)


    C117862E11
  1. Disconnect the A27 ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    A27-2 (GND1) - Body ground
    Below 1 Ω
    A27-24 (GND2) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A27-25 (IG) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


4.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (ABS WARNING LIGHT)
  1. Select the Active Test, generate a control command, and then check that the ABS warning light operates.

    Skid control ECU 
    Tester Display
    Test Part
    Control Range
    Diagnostic Notes
    ABS Warning Light
    Turns ABS warning light
    ON or OFF
    Observe combination meter

    OK:
    The ABS warning light is turned on or off.

HINT:
When the ABS warning light remains illuminated, opens in the wire harness of the combination meter or abnormalities in the meter circuit should be considered.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)