Home › BRAKE › BRAKE CONTROL › BRAKE ACTUATOR (w/o VSC)

BRAKE ACTUATOR (w/o VSC) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 1AZ-FE)
  1. Remove the air cleaner case (Click here).



3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 2AZ-FE)
  1. Remove the air cleaner case (Click here).



4. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 3ZR-FAE)
  1. Remove the air cleaner case (Click here).



5. DRAIN BRAKE FLUID

NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.



6. DISCONNECT BRAKE LINE


    C129066
  1. Using a union nut wrench, disconnect the 6 brake lines from the actuator.



    C129067E01
  1. Place tags or marks to identify the installation locations of each brake line.



7. REMOVE BRAKE ACTUATOR ASSEMBLY WITH BRACKET


    C129068
  1. Release the latch of the actuator connector and disconnect the connector.



    C128743
  1. Disconnect the brake tube clamp from the bracket.



    C129069
  1. Remove the 3 nuts and actuator with bracket.

    NOTICE:
    Be careful not to damage the brake tubes.