VEHICLE STABILITY CONTROL SYSTEM > TC and CG Terminal Circuit |

| 1.CHECK DLC3 (TC VOLTAGE) |
![]() |
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E16-13 (TC) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 2.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output. | A |
| DTC is output. | B |
|
| ||||
| A | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (DLC3 - ECM) |
![]() |
Turn the ignition switch off.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E16-13 (TC) - A12-27 (TC) | Always | Below 1 Ω |
| A12-27 (TC) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| E16-13 (TC) - A12-27 (TC) | Always | Below 1 Ω |
| A12-41 (TC) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E16-4 (CG) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output. | A |
| DTC is output. | B |
|
| ||||
| A | ||
| ||