ABS AND TRACTION ACTUATOR (w/ VSC) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 1AZ-FE) |
Remove the air cleaner case (Click here).
| 3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 2AZ-FE) |
Remove the air cleaner case (Click here).
| 4. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 2GR-FE) |
Remove the air cleaner case (Click here).
| 5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY (for 3ZR-FAE) |
Remove the air cleaner case (Click here).
| 6. DRAIN BRAKE FLUID |
| 7. DISCONNECT CONNECTOR |
![]() |
Pull the lock lever upward and disconnect the connector.
| 8. DISCONNECT BRAKE LINE |
![]() |
Using a union nut wrench, disconnect the 6 brake lines from the actuator.
![]() |
Place tags or marks to identify the installation locations of each brake line.
| 9. REMOVE BRAKE ACTUATOR WITH BRACKET |
![]() |
Disconnect the brake tube clamp from the bracket.
![]() |
Remove the 3 nuts and actuator with bracket.