DTC P2118 Throttle Actuator Control Motor Current Range / Performance |

| DTC No. | DTC Detection Condition | Trouble Area |
| P2118 | An open in the electronic throttle control system power source (+BM) circuit (1 trip detection logic). |
|

| 1.READ VALUE USING INTELLIGENT TESTER (+BM VOLTAGE) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT / Data List / +BM voltage.
Read the value displayed on the tester.
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (+BM CIRCUIT) |
![]() |
Disconnect the ECM connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A12-3 (+BM) - B32-105 (E1) | Always | 11 to 14 V |
| *1 | Front view of wire harness connector (to ECM) |
| *2 | Front view of wire harness connector (to ECM) |
Reconnect the ECM connectors.
|
| ||||
| OK | ||
| ||