DTC P0327 Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor) |
DTC P0328 Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0327 | The output voltage of the knock sensor is 0.5 V or less (1 trip detection logic). |
|
| P0328 | The output voltage of the knock sensor is 4.5 V or higher (1 trip detection logic). |
|

| Item | Content |
| Terminal | KNK1 - EKNK |
| Equipment Setting | 1 V/DIV. 1 ms./DIV. |
| Condition | Keep engine speed at 4000 rpm with warm engine |

| 1.READ VALUE USING INTELLIGENT TESTER (KNOCK FEEDBACK VALUE) |
Connect the intelligent tester to the DLC3.
Start the engine and turn the tester on.
Warm up the engine.
Enter the following menus: Powertrain / Engine and ECT / Data List / Knock Feedback Value.
Read the values displayed on the tester while the vehicle is being driven.
| Malfunction does not occur | Knock Feedback Value changes |
| Malfunction occurs | Knock Feedback Value does not change |
|
| ||||
| OK | ||
| ||
| 2.INSPECT ECM (KNK1 VOLTAGE) |
![]() |
Disconnect the knock sensor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| j1-2 (KNK1) - j1-1 (EKNK) | Ignition switch ON | 4.5 to 5.5 V |
| *1 | Front view of wire harness connector (to Knock Sensor) |
Reconnect the knock sensor connector.
|
| ||||
| OK | |
| 3.INSPECT KNOCK SENSOR |
![]() |
Remove the knock sensor.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2 (KNK1) - 1 (EKNK) | 20°C (68°F) | 120 to 280 kΩ |
| *1 | Component without harness connected (Knock Sensor) |
| *2 | Ohmmeter |
| *3 | Knock Sensor |
Reinstall the knock sensor.
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (ECM - KNOCK SENSOR) |
![]() |
Disconnect the knock sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| j1-2 (KNK1) - B32-110 (KNK1) | Always | Below 1 Ω |
| j1-1 (EKNK) - B32-111 (EKNK) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| j1-2 (KNK1) or B32-110 (KNK1) - Body ground | Always | 10 kΩ or higher |
| j1-1 (EKNK) or B32-111 (EKNK) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Knock Sensor) |
| *2 | Front view of wire harness connector (to ECM) |
Reconnect the knock sensor connector.
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||