DTC P0560 System Voltage |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0560 | An open in the ECM back-up power source circuit (1 trip detection logic). |
|

| 1.CHECK HARNESS AND CONNECTOR (ECM - BATTERY) |
![]() |
Disconnect the ECM connector.
Disconnect the cable from the negative (-) battery terminal.
Disconnect the cable from the positive (+) battery terminal.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A12-20 (BATT) - Positive battery terminal | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| A12-20 (BATT) or Positive battery terminal - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to ECM) |
Reconnect the ECM connector.
Reconnect the cable to the positive (+) battery terminal.
Reconnect the cable to the negative (-) battery terminal.
|
| ||||
| OK | |
| 2.INSPECT BATTERY |
Check the battery voltage.
|
| ||||
| OK | |
| 3.CHECK BATTERY TERMINAL |
Check that the battery terminals are not loose or corroded.
|
| ||||
| OK | |
| 4.CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Clear the DTCs (Click here).
Turn the ignition switch off and turn the tester off.
Start the engine and turn the tester on.
Enter the following menus: Powertrain / Engine and ECT/ DTC.
Read the DTCs.
| Result | Proceed to |
| DTC P0560 is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||