Home › TRANSMISSION ยท U241E AUTOMATIC TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM

AUTOMATIC TRANSAXLE SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. The ECM of this system is connected to the CAN and multiplex communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN and multiplex communication systems.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Refer to How to Troubleshoot ECU Controlled Systems in the Introduction section (Click here).


    NEXT


    3.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    4.CONNECT INTELLIGENT TESTER TO DLC3*

      NEXT


      5.CHECK AND CLEAR DTCS AND FREEZE FRAME DATA*
      1. Refer to the DTC check / clear (Click here).


      NEXT


      6.VISUAL INSPECTION

        NEXT


        7.SETTING CHECK MODE DIAGNOSIS*
        1. Refer to the check mode procedure (Click here).


        NEXT


        8.PROBLEM SYMPTOM CONFIRMATION
        1. Refer to the road test (Click here).

          Result:
          Result
          Proceed to
          Symptom does not occur
          A
          Symptom occurs
          B



        B.
        GO TO STEP 10
        A


        9.SYMPTOM SIMULATION
        1. Refer to the how to proceed with troubleshooting (Click here).


        NEXT


        10.DTC CHECK*
        1. Refer to the DTC check / clear (Click here).

          Result:
          Result
          Proceed to
          DTC is not output
          A
          DTC is output
          B



        B.
        GO TO STEP 18
        A


        11.BASIC INSPECTION
        1. Refer to the automatic transmission fluid (Click here).

        2. Refer to the park / neutral position switch (Click here).

        3. Refer to the floor shift assembly (Click here).



        NG.
        GO TO STEP 21
        OK


        12.MECHANICAL SYSTEM TESTS
        1. Refer to the mechanical system tests (Click here).



        NG.
        GO TO STEP 17
        OK


        13.HYDRAULIC TEST
        1. Refer to the hydraulic test (Click here).



        NG.
        GO TO STEP 17
        OK


        14.MANUAL SHIFTING TEST
        1. Refer to the manual shifting test (Click here).



        NG.
        GO TO STEP 16
        OK


        15.PROBLEM SYMPTOMS TABLE CHAPTER 1
        1. Refer to the problem symptoms table (Click here).



        NG.
        GO TO STEP 19
        OK


        16.PROBLEM SYMPTOMS TABLE CHAPTER 2
        1. Refer to the problem symptoms table (Click here).


        NEXT


        17.PART INSPECTION


          NG.
          GO TO STEP 21
          OK


          18.DTC CHART
          1. Refer to the diagnostic trouble code chart (Click here).


          NEXT


          19.CIRCUIT INSPECTION

            NEXT


            20.IDENTIFICATION OF PROBLEM

              NEXT


              21.REPAIR OR REPLACE

                NEXT


                22.CONFIRMATION TEST

                  NEXT

                  END