DTC P0724 Brake Switch "B" Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0724 | Stop light switch remains ON even when vehicle is driven in GO (30 km/h (18.63 mph) or more) and STOP (less than 3 km/h (1.86 mph)) pattern 5 times (2 trip detection logic) |
|

| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Stop Light Switch | Stop light switch status/ ON or OFF |
| - |
| 1.INSPECT STOP LIGHT SWITCH ASSEMBLY |
![]() |
Remove the stop light switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
| 1 - 2 | Switch pin pushed in | 10 kΩ or higher |
| Switch pin free | Below 1 Ω | |
| 3 - 4 | Switch pin pushed in | Below 1 Ω |
| Switch pin free | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH ASSEMBLY - ECM) |
![]() |
Install the stop light switch assembly.
Measure the voltage according to the value(s) in the table below when the brake pedal is depressed and released.
| Tester Connection | Condition | Specified Condition |
| A12-36 (STP) - Body ground | Brake pedal is depressed | 11 to 14 V |
| Brake pedal is released | Below 1 V |
|
| ||||
| OK | ||
| ||