DTC P0504 Brake Switch "A" / "B" Correlation |
| Signal | Brake Pedal Released | In Transition | Brake Pedal Depressed |
| STP | OFF | ON | ON |
| ST1- | ON | ON | OFF |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0504 | Conditions (a), (b) and (c) continue for 0.5 seconds or more (1 trip detection logic): (a) The ignition switch is turned to ON. (b) The brake pedal is released. (c) The STP signal is off when the ST1- signal is off. |
|

| Brake Pedal Operation | Specified Condition |
| Depressed | STP signal ON |
| Released | STP signal OFF |
| 1.CHECK STOP LIGHT SWITCH ASSEMBLY (TERMINAL VOLTAGE) |
![]() |
Disconnect the stop light switch assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A66-2 - Body ground | Always | 11 to 14 V |
| A66-4 - Body ground | Ignition switch ON | 11 to 14 V |
| *1 | Front view of wire harness connector (to Stop Light Switch) |
Reconnect the stop light switch assembly connector.
|
| ||||
| OK | |
| 2.INSPECT STOP LIGHT SWITCH ASSEMBLY |
![]() |
Remove the stop light switch assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Switch pin released | Below 1 Ω |
| Switch pin pushed | 10 kΩ or higher | |
| 3 - 4 | Switch pin released | 10 kΩ or higher |
| Switch pin pushed | Below 1 Ω |
Reinstall the stop light switch assembly.
|
| ||||
| OK | |
| 3.CHECK ECM (STP AND ST1- VOLTAGE) |
![]() |
Disconnect the ECM connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Brake Pedal Operation | Specified Condition |
| A12-35 (ST1-) - Body ground | Brake pedal released | 11 to 14 V |
| Brake pedal depressed | Below 1.5 V | |
| A12-36 (STP) - Body ground | Brake pedal released | Below 1.5 V |
| Brake pedal depressed | 11 to 14 V |
Reconnect the ECM connector.
|
| ||||
| OK | ||
| ||