Home › ENGINE ยท 2GR-FE › LUBRICATION › LUBRICATION SYSTEM

LUBRICATION SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK ENGINE OIL LEVEL
  1. Warm up and stop the engine, and then wait for 5 minutes. The oil level should be between the dipstick low and full level marks.
    If the oil level is low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not add engine oil to above the full level mark.



2. CHECK ENGINE OIL QUALITY
  1. Check the oil for deterioration, water contamination, discoloring or thinning.
    If the quality is visibly poor, replace the oil.



3. CHECK ENGINE OIL PRESSURE
  1. Disconnect the oil pressure switch connector.



    A131918
  1. Using a 24 mm deep socket wrench, remove the oil pressure switch.



    A131919
  1. Install the oil pressure gauge.

  1. Warm up the engine.

  1. Measure the oil pressure.

    Standard oil pressure:
    Condition
    Specified Condition
    Idle
    80 kPa (0.8 kgf/cm2, 11.6 psi) or more
    6,000 rpm
    380 kPa (3.9 kgf/cm2, 55.5 psi) or more

    If the oil pressure is not as specified, check the oil pump (Click here).

  1. Remove the oil pressure gauge.



    A132149E01
  1. Apply adhesive to 2 or 3 threads of the oil pressure switch.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent



    A131918
  1. Install the oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installation of the switch.

  1. Connect the oil pressure switch connector.

  1. Start the engine and check for engine oil leaks.