DTC B2278 Engine Switch Circuit Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2278 | Communication is abnormal between the main body ECU and engine switch or the engine switch is defective. |
|

| 1.READ VALUE USING INTELLIGENT TESTER (START SWITCH 1 AND 2) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG) and turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the value displayed on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Start Switch1 | Start Switch 1/ON or OFF | ON: Engine switch on (IG) OFF: Engine switch off | - |
| Start Switch2 | Start Switch 2/ON or OFF | ON: Engine switch on (IG) OFF: Engine switch off | - |
|
| ||||
| OK | |
| 2.CHECK SWITCH CONDITION (ENGINE SWITCH) |
Make sure that the electrical key is inside the cabin.
With the shift lever in P, check that the power source mode changes as shown below each tine the engine switch is pushed.
|
| ||||
| OK | ||
| ||
| 3.INSPECT ENGINE SWITCH |
![]() |
Remove the engine switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 7 (SS1) - 5 (GND) | Pushed | Below 1 Ω |
| 2 (SS2) - 5 (GND) | Pushed | Below 1 Ω |
| 7 (SS1) - 5 (GND) | Not pushed | 10 kΩ or higher |
| 2 (SS2) - 5 (GND) | Not pushed | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (ENGINE SWITCH - MAIN BODY ECU AND BODY GROUND) |
![]() |
Disconnect the E31 engine switch connector.
Disconnect the E19 main body ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E31-7 (SS1) - E19-10 (SSW1) | Always | Below 1 Ω |
| E31-2 (SS2) - E19-9 (SSW2) | Always | Below 1 Ω |
| E31-5 (GND) - Body ground | Always | Below 1 Ω |
| E31-7 (SS1) or E19-10 (SSW1) - Body ground | Always | 10 kΩ or higher |
| E31-2 (SS2) or E19-9 (SSW2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||