Home › ENGINE ยท 3ZR-FAE › STARTING › ENTRY AND START SYSTEM

ENTRY AND START SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the push-button start function.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Using the intelligent tester, check if the CAN communication system is functioning normally (Click here).
      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    GO TO DIAGNOSTIC TROUBLE CODE CHART
    A


    4.CHECK FOR DTC*
    1. Check for DTCs and note any stored DTCs (Click here ).

    2. Delete the DTC.

    3. Check whether the same DTC(s), relevant to the SFI or entry and start systems, recurs by reproducing the symptoms indicated by the noted DTC(s) in first step above.
      Result 
      Result
      Proceed to
      DTC output does not reoccur
      A
      SFI system DTC output reoccurs
      B
      Entry and start system DTC output reoccurs
      C



    B.
    GO TO SFI SYSTEM

    C.
    GO TO STEP 7
    A


    5.PROBLEM SYMPTOMS TABLE

      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    GO TO STEP 7
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here)

    2. Data List / Active Test (Click here)


    NEXT


    7.ADJUST, REPAIR OR REPLACE

      NEXT


      8.CONFIRMATION TEST

        NEXT

        END