Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > TS and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

If the vehicle is stationary during sensor check mode, speed sensor malfunctions cannot be detected. The vehicle must be driven for speed sensor malfunctions to be detected.

HINT:
Change to sensor check mode by connecting terminals 12 (TS) and 4 (CG) of the DLC3, and turning the ignition switch from off to ON.


WIRING DIAGRAM


C194154E02


INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.CHECK HARNESS AND CONNECTOR (DLC3 - SKID CONTROL ECU/BODY GROUND)


    C194164E02
  1. Disconnect the skid control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E16-4 (CG) - Body ground
    Always
    Below 1 Ω
    E16-12 (TS) - A67-33 (TS)
    Always
    Below 1 Ω
    A67-33 (TS) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)