Home › TRANSMISSION ยท CLUTCH › CLUTCH PEDAL (for LHD)

CLUTCH PEDAL (for LHD) > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B129996
  1. Remove the 2 screws.

  1. Detach the 3 claws and remove the cover.



2. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Knee Airbag)


B127987
  1. Remove the 4 bolts and driver side knee airbag.

  1. Disconnect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)


B132919
  1. Remove the 2 screws.

  1. Using a screwdriver, detach the 8 claws and remove the lower instrument panel finish panel.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE UPPER INSTRUMENT PANEL
  1. Remove the upper instrument panel (Click here).



5. DISCONNECT CLUTCH START SWITCH CONNECTOR (w/ Entry and Start System)
  1. Disconnect the clutch start switch connector.

  1. Remove the nut and clutch start switch from the clutch pedal support.



6. DISCONNECT CLUTCH SWITCH CONNECTOR (w/ Cruise Control System)
  1. Disconnect the clutch switch connector.

  1. Remove the nut and clutch switch from the clutch pedal support.



7. REMOVE PUSH ROD CLEVIS PIN


C206282
  1. Remove the clip and pin.



8. REMOVE CLUTCH PEDAL ASSEMBLY


C125481
  1. Remove the bolt, 2 nuts and clutch pedal.