Home › BODY ELECTRICAL › LIGHTING › BACK-UP LIGHT SWITCH

BACK-UP LIGHT SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE BACK-UP LIGHT SWITCH ASSEMBLY
  1. 1AZ-FE:
    Remove the back-up light switch (Click here).

  1. 2AZ-FE:
    Remove the back-up light switch (Click here).