DTC P0796 Pressure Control Solenoid "C" Performance (Shift Solenoid Valve SL3) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0796 | Gear required by the ECM does not match the actual gear when driving (2 trip detection logic) |
|
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Control the Shift Position | [Test Details] Operate the shift solenoid valve and set each shift lever position by yourself [Vehicle Condition]
| 1st / 2nd / 3rd / 4th / 5th | Possible to check the operation of the shift solenoid valves |
| 1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P0796) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC / Current or Pending.
Read the DTCs using the tester.
| Result | Proceed to |
| P0796 | A |
| P0796 and other DTCs | B |
|
| ||||
| A | |
| 2.INSPECT SHIFT SOLENOID VALVE SL3 |
![]() |
Remove the shift solenoid valve SL3.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 5.0 to 5.6 Ω |
Connect the battery's positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector. Then check that the valve moves and makes an operating sound.
|
| ||||
| OK | |
| 3.INSPECT TRANSMISSION VALVE BODY ASSEMBLY |
Check the transmission valve body assembly.
|
| ||||
| OK | |
| 4.INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY |
Check the torque converter clutch assembly (Click here).
|
| ||||
| OK | ||
| ||