Home › BODY › ENGINE HOOD / DOOR › HOOD (w/ Hood Moulding)

HOOD (w/ Hood Moulding) > INSTALLATION

for Preparation Click here



1. INSTALL CUSHION RUBBER
  1. Install the 4 cushion rubbers.



2. INSTALL HOOD AUXILIARY HOOK CATCH


    B252934
  1. Install the hood auxiliary hook catch with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



3. INSTALL RADIATOR SUPPORT OPENING COVER


B209240
  1. Install the radiator support opening cover with the 9 clips.



4. INSTALL HOOD HINGE ASSEMBLY LH


B255914
  1. Install the hood hinge with the 2 bolts.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



5. INSTALL HOOD HINGE ASSEMBLY RH
  1. Install the hood hinge with the 2 bolts.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



6. INSTALL HOOD SUB-ASSEMBLY


B255913E01
  1. Install the hood with the 4 bolts.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }

  1. Adjust the hood position (Click here).



7. INSTALL HOOD AUXILIARY CATCH HOOK ASSEMBLY


    B252933
  1. Temporarily install the hook with the 2 bolts.



8. INSTALL AUXILIARY CATCH RELEASE LEVER ASSEMBLY


    B252932
  1. Attach the claw.

  1. Temporarily install the auxiliary catch release lever assembly with the bolt.



    B252931
  1. Install the hood auxiliary catch hook rod as indicated by the arrow the illustration.



    B254017E01
  1. Tighten the 3 bolts to install the auxiliary catch release lever assembly and hood auxiliary catch hook assembly.

    HINT:
    Tighten the bolts in the order shown in the illustration.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



9. CONNECT WINDSHIELD WASHER HOSE


    B255802
  1. Attach the 3 clamps to connect the washer hose.



10. INSTALL WASHER NOZZLE SUB-ASSEMBLY


11. INSTALL NO. 1 HOOD TO FRONT END PANEL SEAL


    B252929
  1. Attach the 5 clips to install the No. 1 hood to front end panel seal.



12. INSTALL HOOD INSULATOR


    B252928
  1. Attach the 2 claws.

  1. Install the hood insulator with the 8 clips.



13. INSTALL FRONT HOOD MOULDING ASSEMBLY


B254747
  1. Install the front hood moulding with the 6 nuts.