FUEL PUMP > REMOVAL |
![]() |
| 1. REMOVE FUEL TANK ASSEMBLY |
Remove the fuel tank assembly (Click here).
| 2. DISCONNECT FUEL EMISSION HOSE |
![]() |
Disconnect the purge line hose, air inlet line hose and fuel emission hose from the fuel suction plate.
| *1 | Purge Line Hose |
| *2 | Air Inlet Line Hose |
| *3 | Fuel Emission Hose |
| *4 | Retainer |
Pinch the retainer as shown in the illustration, and then disconnect the fuel emission hose from the fuel suction plate.
| 3. DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY |
![]() |
Remove the joint clip and fuel tank main tube.
| 4. REMOVE FUEL TANK VENT TUBE SET PLATE |
![]() |
Remove the 8 bolts and set plate.
| 5. REMOVE FUEL SUCTION WITH PUMP ASSEMBLY |
![]() |
Disconnect the fuel hose and remove the fuel suction with pump from the fuel tank.
![]() |
Remove the gasket from the fuel suction with pump.
| *1 | Gasket |
| 6. REMOVE NO. 1 FUEL SUB-TANK |
![]() |
Disconnect the wire harness connector.
![]() |
Using needle nose pliers, remove the E-ring.
![]() |
Remove the 2 springs from the 2 shafts.
![]() |
Detach the 2 claws and remove the No. 1 fuel sub-tank.
![]() |
Detach the claw of the jet pump nozzle.
| *1 | Jet Pump |
| *2 | Screwdriver |
Using a screwdriver, remove the jet pump.
![]() |
Remove the O-ring from the jet pump.
| *1 | Jet Pump |
| *2 | O-Ring |
| 7. REMOVE NO. 1 FUEL SUCTION SUPPORT |
![]() |
Using needle-nose pliers, detach the 2 claws and remove the No. 1 fuel suction support.
| 8. REMOVE FUEL PUMP ASSEMBLY |
![]() |
Detach the 5 claws on the filter and remove the fuel pump from the fuel filter.
![]() |
Disconnect the fuel pump connector.
![]() |
Remove the O-ring from the fuel filter.
Remove the fuel pump spacer from the fuel pump assembly.
| *1 | O-Ring |
| *2 | Fuel Pump Spacer |