AIR CONDITIONING UNIT > REMOVAL |
| 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM |
Start the engine.
Turn the A/C switch on.
Operate the cooler compressor while the engine speed is approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.
Stop the engine.
Recover the refrigerant from the A/C system using a refrigerant recovery unit.
| 2. DRAIN ENGINE COOLANT |
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE TUBE SUB-ASSEMBLY |
![]() |
Remove the bolt.
Remove plate, as shown in the illustration.
Disconnect the suction tube and liquid tube.
![]() |
Remove the 2 O-rings from the suction tube and liquid tube.
| 5. DISCONNECT INLET HEATER WATER HOSE |
![]() |
Using pliers, grip the claws of the clip and slide the clip.
Disconnect the heater water inlet hose.
| 6. DISCONNECT OUTLET HEATER WATER HOSE |
| 7. REMOVE STEERING COLUMN ASSEMBLY |
Remove the steering column (Click here).
| 8. REMOVE UPPER INSTRUMENT PANEL |
Remove the upper instrument panel (Click here).
| 9. REMOVE LOWER INSTRUMENT PANEL |
Remove the lower instrument panel (Click here).
| 10. REMOVE DEFROSTER NOZZLE ASSEMBLY |
![]() |
Detach the 3 claws and remove the defroster nozzle.
| 11. REMOVE NO. 1 INSTRUMENT PANEL BRACE SUB-ASSEMBLY |
![]() |
Fold the floor carpet back.
![]() |
Disconnect the clamp and disconnect the wire harness.
![]() |
Remove the bolt, nut, screw, and instrument panel brace.
| 12. REMOVE AIR DUCT REAR |
![]() |
Disconnect the 2 clamps and disconnect the wire harness.
![]() |
Detach the 3 claws and remove the air duct rear.
| 13. REMOVE AIR DUCT |
![]() |
Detach the 2 claws and remove the air duct.
| 14. REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY |
![]() |
Detach the 2 clamps.
Disconnect the connector.
![]() |
Remove the screw and air conditioning amplifier.
| 15. REMOVE DRAIN COOLER HOSE |
![]() |
Remove the drain hose.
| 16. REMOVE INSTRUMENT PANEL REINFORCEMENT |
Disconnect the 12 clamps.

Remove the 4 bolts and disconnect the ground wire.

Remove the 3 bolts.

Remove the 6 bolts and instrument panel reinforcement.

| 17. REMOVE AIR CONDITIONING UNIT ASSEMBLY |
![]() |
Remove the bolt, nut and air conditioning unit.