Home › TRANSMISSION ยท EB61 MANUAL TRANSAXLE › MANUAL TRANSAXLE ASSEMBLY

MANUAL TRANSAXLE ASSEMBLY > REMOVAL

for Preparation Click here


NOTICE:
When the transaxle is removed, be sure to use a new clutch release with bearing cylinder and new installation bolts. Removal of the transaxle allows the compressed clutch release with bearing cylinder to return to its original position, and dust could damage the seal of the clutch release with bearing cylinder, possibly causing clutch fluid leaks.



1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
  1. Remove the engine assembly with transaxle (Click here).



2. REMOVE STARTER ASSEMBLY
  1. Remove the starter assembly (Click here).



3. REMOVE ENGINE WIRE


C200444
  1. Remove the bolt, clamp and engine wire.



4. REMOVE MANUAL TRANSAXLE ASSEMBLY


    C200443
  1. Disconnect the back-up light switch connector and remove the bolt and engine wire from the manual transaxle.



    C206809
  1. Remove the 8 bolts and manual transaxle.



5. REMOVE FRONT ENGINE MOUNTING BRACKET


    C197778
  1. Remove the 4 bolts and front engine mounting bracket.



6. REMOVE ENGINE MOUNTING BRACKET LH


    C200440
  1. Remove the 4 bolts and engine mounting bracket LH.



7. REMOVE REAR ENGINE MOUNTING BRACKET


    C206811
  1. Remove the 4 bolts and rear engine mounting bracket.



8. REMOVE ORIFICE TO FLEXIBLE HOSE TUBE


C204460
  1. Using a union nut wrench, separate the orifice to flexible hose tube from the clutch orifice assembly.

  1. Remove the bolt and orifice to flexible hose tube.



9. REMOVE CLUTCH RELEASE CYLINDER TO ACCUMULATOR TUBE


C204175
  1. Using a union nut wrench, remove the clutch release cylinder to accumulator tube.



10. REMOVE CLUTCH ORIFICE ASSEMBLY


C204176
  1. Remove the 2 bolts and clutch orifice assembly.



11. REMOVE CLUTCH FLEXIBLE HOSE BRACKET


    C200436
  1. Remove the bolt and clutch flexible hose bracket from the manual transaxle.



12. REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY


C199329
  1. Using a union nut wrench, separate the clutch release bleeder sub-assembly from the clutch release cylinder to bleeder tube.

  1. Remove the 2 bolts and clutch release bleeder sub-assembly from the manual transaxle assembly.



13. REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY


    C199330
  1. Remove the clutch tube boot from the manual transaxle assembly.



    C199331
  1. Remove the 3 bolts and clutch release with bearing cylinder assembly and clutch release cylinder to bleeder tube.



    C199287
  1. Using a union nut wrench, remove the clutch release cylinder to bleeder tube from the clutch release with bearing cylinder assembly.



14. REMOVE SPEEDOMETER DRIVEN HOLE COVER SUB-ASSEMBLY


    C206813
  1. Remove the bolt and speedometer driven hole cover sub-assembly from the transaxle case.

  1. Remove the O-ring from the speedometer driven hole cover sub-assembly.