Home › BRAKE › PARKING BRAKE › PARKING BRAKE CABLE

PARKING BRAKE CABLE > INSTALLATION

for Preparation Click here



1. INSTALL PARKING BRAKE CABLE


  1. Connect the cable to the backing plate and parking brake shoe lever.

    1. Pass the cable through the backing plate, and then connect the cable to the lever.



    2. Install the cable to the backing plate with the bolt.

      Torque:
      8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



      C127323E01

  1. Install the clamp and clamp bolt (labeled F) to the trailing arm.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

    NOTICE:
    Securely install the clamp.

  1. Install the clamp and clamp bolt (labeled E) to the rear suspension crossmember.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

    NOTICE:
    Securely install the clamp.

  1. Install the clamp and clamp bolt (labeled D) to the crossmember.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

    NOTICE:
    Securely install the clamp.

  1. Install the clamp and clamp bolt (labeled C) to the body.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

    NOTICE:
    Securely install the clamp.

  1. Install the casing cap and casing cap bolt (labeled B) to the body.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

    NOTICE:
    Securely install the casing cap.

  1. Install the cable clamp (labeled A) to the body.

    NOTICE:
    Securely install the clamp.



2. INSTALL PARKING BRAKE EQUALIZER


    C129065E02
  1. Connect the 3 cable ends to the equalizer.



3. INSTALL REAR WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }



4. ADJUST PARKING BRAKE LEVER TRAVEL


    C127319E01
  1. Turn the No. 1 wire adjusting nut until the lever travel is correct.

    OK:
    6 to 8 clicks (without rear brake dragging)
    <Lever pulling force: approximately 200 N (20 kgf, 44 lbf)>

  1. Tighten the lock nut.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }

  1. Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.

    OK:
    6 to 8 clicks (without rear brake dragging)
    <Lever pulling force: approximately 200 N (20 kgf, 44 lbf)>

  1. When operating the parking brake lever, check that the brake warning light illuminates at the first click.

    Standard condition:
    Brake warning light always illuminates at the first click.



5. INSTALL CENTER AIRBAG SENSOR ASSEMBLY
  1. Install the center airbag sensor (Click here).

    HINT:
    Refer to the procedures from the installation of the center airbag sensor up until the checking of the SRS warning light.