Home › BRAKE › PARKING BRAKE › PARKING BRAKE CABLE

PARKING BRAKE CABLE > REMOVAL

for Preparation Click here



1. REMOVE CENTER AIRBAG SENSOR ASSEMBLY
  1. Remove the center airbag sensor (Click here).

    HINT:
    Refer to the procedures from the disconnection of the negative battery cable up until the removal of the center airbag sensor.



2. LOOSEN LOCK NUT AND NO. 1 WIRE ADJUSTING NUT


C127319E01


3. REMOVE PARKING BRAKE EQUALIZER


    C129065E02
  1. Disconnect the 3 cable ends and then remove the equalizer.



4. REMOVE REAR WHEEL


5. REMOVE PARKING BRAKE CABLE



C127323E01

  1. Remove the cable clamp (labeled A) from the body.

  1. Remove the casing cap bolt (labeled B) from the body.

  1. Remove the clamp bolt (labeled C) from the body.

  1. Remove the clamp bolt (labeled D) from the crossmember.

  1. Remove the clamp bolt (labeled E) from the rear suspension crossmember.

  1. Remove the clamp bolt (labeled F) from the trailing arm.

  1. Disconnect the cable from the parking brake shoe lever and backing plate.

    1. Disconnect the cable from the lever (Click here).

    2. Remove the bolt and disconnect the cable from the backing plate.