Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

DTC    C1251/51    Open in Pump Motor Circuit

for Preparation Click here


DESCRIPTION

The motor relay (semiconductor relay) is housed in the skid control ECU and drives the pump motor based on a signal from the skid control ECU.

DTC No.
DTC Detection Condition
Trouble Area
C1251/51
When either condition below is met:
  1. Actuator pump motor does not operate properly.
  2. Open in actuator pump motor circuit continues for at least 2 seconds.
  1. Harness or connector
  2. Brake actuator (Skid control ECU)

WIRING DIAGRAM

Refer to DTC C0226/21, C0236/22, C0246/23, C0256/24 .

INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (MOTOR RELAY)
  1. Select the Active Test, generate a control command, and then check that the ABS motor relay operates.

    Skid control ECU 
    Tester Display
    Test Parts
    Control Range
    Diagnosis Note
    Motor Relay
    Turn ABS motor relay
    ON or OFF
    Operation sound of motor can be heard

    OK:
    Operation sound of ABS motor is heard.



NG
Go to step 3
OK


2.RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Start the engine.

  1. Drive the vehicle at a speed of 6 km/h (4 mph) or more for several seconds.

  1. Check if the same DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)  

3.INSPECT FUSE (ABS1)
  1. Remove the ABS1 fuse from the engine room No. 1 relay block.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


4.CHECK WIRE HARNESS (SKID CONTROL ECU - BATTERY AND BODY GROUND)


    C117862E06
  1. Disconnect the A27 ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    A27-2 (GND1) - Body ground
    Below 1 Ω
    A27-24 (GND2) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Specified Condition
    A27-23 (+BM) - Body ground
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)