Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR INLET CONTROL SERVO MOTOR

AIR INLET CONTROL SERVO MOTOR > REMOVAL

for Preparation Click here



1. REMOVE BLOWER UNIT ASSEMBLY
  1. Remove the blower (Click here).



2. REMOVE AIR INLET CONTROL SERVO MOTOR


    E125444E02
  1. Inspect the servo motor operation.



      E125445E03
    1. Connect the positive (+) lead from the battery to terminal 4 and negative (-) lead to terminal 5, and then check that the arm turns to the "FRESH" side smoothly.

    2. Connect the positive (+) lead from the battery to terminal 5 and negative (-) lead to terminal 4, and then check that the arm turns to the "RECIRCULATION" side smoothly.
      If the operation is not as specified, replace the air inlet control servo motor.