Home › TRANSMISSION ยท CLUTCH › CLUTCH UNIT (for 1AZ-FE, 2AZ-FE)

CLUTCH UNIT (for 1AZ-FE, 2AZ-FE) > INSTALLATION

for Preparation Click here



1. INSTALL CLUTCH DISC ASSEMBLY


C127508E01
  1. Insert SST in the disc, then insert them in the flywheel.

    SST
    09301-00210  

    NOTICE:
    Take care not to insert the clutch disc in the wrong direction.



2. INSTALL CLUTCH COVER ASSEMBLY


C127509E01
  1. Align the matchmarks on the cover and flywheel.

  1. Following the procedures shown in the illustration, tighten the 6 bolts in order, starting with the bolt located near the knock pin on the top.

    Torque:
    19 N*m{ 195 kgf*cm , 14 ft.*lbf }

    HINT:
    1. Following the order in the illustration, tighten the bolts one at a time, evenly.
    2. Move SST up and down, and right and left lightly after checking that the disc is in the center to tighten the bolts.

    SST
    09301-00210  



3. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY


    C206521E01
  1. Using a dial indicator with a roller instrument, measure the diaphragm spring tip alignment.

    Maximum misalignment:
    0.5 mm (0.020 in.)

    If the alignment is more than the maximum, use SST to adjust the diaphragm spring tip alignment.
    SST
    09333-00013  



4. INSTALL RELEASE FORK SUPPORT
  1. Install the release fork support on the transaxle.

    Torque:
    47 N*m{ 480 kgf*cm , 35 ft.*lbf }



5. INSTALL CLUTCH RELEASE FORK BOOT


6. INSTALL RELEASE BEARING HUB CLIP


7. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY


    C231082E01
  1. Apply Multemp 8158 Grease or equivalent to the contact surfaces of the release fork and release bearing, fork and push rod, and fork and fork support.

    Grease:
    Multemp 8158 Grease or equivalent

  1. Install the fork to the release bearing.



8. INSTALL CLUTCH RELEASE BEARING ASSEMBLY


    C133434
  1. Apply clutch spline grease to the input shaft spline.

    Grease:
    Toyota Genuine Clutch Spline Grease or equivalent



    C127501
  1. Install the bearing with release fork to the transaxle.

    NOTICE:
    After the installation, move the fork forward and backward to check that the release bearing slides smoothly.



9. INSTALL MANUAL TRANSAXLE ASSEMBLY
  1. for E352F, E359F:
    Install the manual transaxle assembly (Click here).

  1. for E352:
    Install the manual transaxle assembly (Click here).