Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
  1. Attach the rear side hook of the front passenger airbag to the rear side airbag door.

  1. Bend the front side hook so that it attaches to the front side airbag door.

  1. Install the instrument panel upper (Click here).

  1. Install the 2 bolts to the reinforcement.

    Torque:
    20 N*m{ 203 kgf*cm , 14 ft.*lbf }



    B127928E01
  1. Connect the connector to the airbag.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Attach the wire harness clamp to the bracket.



2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).