Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AMBIENT TEMPERATURE SENSOR (for Automatic Air Conditioning System)

AMBIENT TEMPERATURE SENSOR (for Automatic Air Conditioning System) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



2. REMOVE FRONT BUMPER COVER
  1. w/ Under Guard:
    Remove the front bumper cover (Click here).

  1. w/o Under Guard:
    Remove the front bumper cover (Click here).



3. REMOVE AMBIENT TEMPERATURE SENSOR
  1. Using a screwdriver, pull out the sensor, then disconnect the connector.

    HINT:
    Tape the screwdriver tip before use.