Home › TRANSMISSION ยท CLUTCH › CLUTCH UNIT (for 1AZ-FE, 2AZ-FE)

CLUTCH UNIT (for 1AZ-FE, 2AZ-FE) > REMOVAL

for Preparation Click here



1. REMOVE MANUAL TRANSAXLE ASSEMBLY
  1. for E352F, E359F:
    Remove the manual transaxle assembly (Click here).

  1. for E352:
    Remove the manual transaxle assembly (Click here).



2. REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY


C127501
  1. Remove the fork together with the clutch release bearing from the transaxle.



3. REMOVE CLUTCH RELEASE FORK BOOT


4. REMOVE CLUTCH RELEASE BEARING ASSEMBLY
  1. Remove the bearing from the clutch release fork.



5. REMOVE RELEASE BEARING HUB CLIP


6. REMOVE RELEASE FORK SUPPORT
  1. Remove the support and release fork from the transaxle.



7. REMOVE CLUTCH COVER ASSEMBLY


C206377E01
  1. Put matchmarks on the clutch cover assembly and flywheel sub-assembly.
    Text in Illustration 
    *1
    Matchmark

  1. Loosen each set bolt one turn at a time in the order shown in the illustration until the spring tension is released.

  1. Remove the set bolts and pull off the clutch cover assembly.

    NOTICE:
    Do not drop the clutch disc assembly.



8. REMOVE CLUTCH DISC ASSEMBLY