Home › BODY › SLIDING ROOF › SLIDING ROOF HOUSING

SLIDING ROOF HOUSING > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE ROOF HEADLINING ASSEMBLY (for Short Body)
  1. Remove the roof headlining (Click here).



3. REMOVE ROOF HEADLINING ASSEMBLY (for Long Body)
  1. Remove the roof headlining (Click here).



4. REMOVE SLIDING ROOF SIDE GARNISH LH


B129367
  1. Using a screwdriver, detach the claws and remove the garnish.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE SLIDING ROOF SIDE GARNISH RH

HINT:
Use the same procedures described for the LH side.



6. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY


B129372
  1. Using a T25 "TORX" driver, remove the 4 screws and glass.

  1. Pull the glass upward to remove it.



7. REMOVE SLIDING ROOF WEATHERSTRIP


8. DISCONNECT SLIDING ROOF DRAIN HOSE
  1. Disconnect the 4 drain hoses.



9. REMOVE SLIDING ROOF HOUSING ASSEMBLY


B129368
  1. Remove the 4 bolts, 8 nuts and housing.

    NOTICE:
    Be careful not to damage the curtain shield airbag when removing the housing.