DTC C1381 Acceleration Sensor Power Supply Voltage Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1381 | At a vehicle speed of more than 3 km/h (2 mph), an acceleration sensor power source malfunction signal is received for 10 seconds or more. |
|
| 1.INSPECT YAW RATE AND DECELERATION SENSOR (IG TERMINAL) |
![]() |
Make sure that there is no looseness in the locking part and connecting part of the connector.
Disconnect the yaw rate and deceleration sensor connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| K25-4 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 2.INSPECT YAW RATE AND DECELERATION SENSOR (GND TERMINAL) |
![]() |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K25-1 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Reconnect the yaw rate and deceleration sensor connector.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 3 km/h (2 mph) or more for at least 10 seconds.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC (C1381) is not output. | A |
| DTC (C1381) is output. | B |
|
| ||||
| A | ||
| ||