DTC C0371 Yaw Rate Sensor (Test Mode DTC) |
DTC C1279 Acceleration Sensor Output Voltage Malfunction (Test Mode DTC) |
| DTC Code | DTC Detection Condition | Trouble Area |
| C0371 | Detected only during Test Mode. | Yaw rate and deceleration sensor |
| C1279 | Detected only during Test Mode. |
|
| 1.CHECK YAW RATE AND DECELERATION SENSOR INSTALLATION |
Check that the yaw rate and deceleration sensor has been installed properly .
|
| ||||
| OK | |
| 2.INSPECT YAW RATE AND DECELERATION SENSOR (IG TERMINAL) |
![]() |
Make sure that there is no looseness in the locking part and connecting part of the connectors.
Disconnect the yaw rate and deceleration sensor connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| K25-4 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | |
| 3.INSPECT YAW RATE AND DECELERATION SENSOR (GND TERMINAL) |
![]() |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K25-1 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||