AIR FUEL RATIO SENSOR > ON-VEHICLE INSPECTION |
| 1. CHECK AIR FUEL RATIO COMPENSATION SYSTEM |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Select the following menu items: Data List / A/FS B1 S1 and O2S B1 S2.
Warm up the A/F sensor with the engine speed at 2,500 rpm for approximately 2 minutes.
Keep the engine speed at 2,500 rpm and confirm that the display of "A/FS B1 S1" is as shown in the illustration.
![]() |
Confirm that the display of "O2S B1 S2" changes between 0 to 1 V with the engine speed at 2,500 rpm.