Home › TRANSMISSION ยท U241E AUTOMATIC TRANSAXLE › DIFFERENTIAL OIL SEAL

DIFFERENTIAL OIL SEAL > REPLACEMENT

for Preparation Click here



1. DRAIN AUTOMATIC TRANSAXLE FLUID
  1. Remove the drain plug, gasket and drain ATF.

  1. Install a new gasket and drain plug.

    Torque:
    47 N*m{ 479 kgf*cm , 35 ft.*lbf }



2. REMOVE FRONT DRIVE SHAFT ASSEMBLY
  1. Remove the drive shaft (Click here).



3. REMOVE DRIVE SHAFT BEARING BRACKET
  1. Remove the 3 bolts and bracket.



4. REMOVE TRANSAXLE HOUSING OIL SEAL LH AND RH


D025835E01
  1. Using SST, tap out the oil seal LH.

    SST
    09308-00010  



    D025827E01
  1. Using SST, tap out the oil seal RH.

    SST
    09308-00010  



5. INSTALL TRANSAXLE HOUSING OIL SEAL LH AND RH
  1. Coat the lip of a new oil seal LH with MP grease.



    D025836E01
  1. Using SST and a hammer, tap in the oil seal LH.

    SST
    09608-32010  
    09950-70010   (09951-07150)

    Standard depth:
    0 +-0.5 mm (0 +-0.020 in.)

  1. Coat the lip of a new oil seal LH with MP grease.



    C129401E01
  1. Using SST and a hammer, tap in the oil seal RH.

    SST
    09608-32010  
    09950-70010   (09951-07150)

    Standard depth:
    0 +-0.5 mm (0 +-0.020 in.)



6. INSTALL DRIVE SHAFT BEARING BRACKET
  1. Install the bracket with the 3 bolts.

    Torque:
    64 N*m{ 653 kgf*cm , 47 ft.*lbf }



7. INSTALL FRONT DRIVE SHAFT ASSEMBLY
  1. Install the front drive shaft (Click here).



8. ADD AUTOMATIC TRANSAXLE FLUID

Fluid type:
Toyota Genuine ATF WS



9. INSPECT TRANSAXLE FLUID LEVEL
  1. Inspect the transaxle fluid level (Click here).