FLOOR SHIFT ASSEMBLY > INSTALLATION |
| 1. INSTALL FLOOR SHIFT ASSEMBLY |
![]() |
Connect the 2 connectors and attach the clamp.
![]() |
Install the floor shift with the 4 bolts.
| 2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
![]() |
Turn the nut of the control cable and push in the lock.
![]() |
Install the control cable onto the shift lever retainer.
![]() |
Slide the slider of the transmission control cable in the direction indicated by the arrow and pull the lock piece outward.
![]() |
Install the transmission control cable end to the shift lever assembly.
![]() |
Push the lock piece into the adjuster case.
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. INSPECT SHIFT LEVER POSITION |
When shifting the lever from the P position to the R position with the ignition switch in the ON position and the brake pedal depressed, make sure that the shift lever moves smoothly and correctly into position.
Start the engine and make sure that the vehicle moves forward when shifting the lever from the N position to the D position and moves rearward when shifting the lever to the R position.
If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.
| 5. ADJUST SHIFT LEVER POSITION |
Apply the parking brake and move the shift lever to the N position.
Remove the rear console box sub-assembly (Click here).
![]() |
Disconnect the end of the transmission control cable assembly from the shift lever assembly.
![]() |
Turn the lock nut counterclockwise. While holding the lock nut, disconnect the transmission control cable from the shift lever retainer.
![]() |
Slide the slider of the transmission control cable in the direction indicated by the arrow and pull the lock piece outward.
![]() |
Turn the lock nut of the transmission control cable counterclockwise. While holding the lock nut, push in the lock.
![]() |
Connect the outer part of the transmission control cable to the shift lever retainer.
![]() |
Install the transmission control cable end to the shift lever assembly.
![]() |
Push the lock piece into the adjuster case.
Install the rear console box sub-assembly .
| 6. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY |
Install the rear console box sub-assembly (Click here).
| 7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY |
![]() |
Install the shift lever knob sub-assembly.